This is a powerful stereo in mono block design made by Carver. It has 2 locking power cords for each . Im downsizing and pieces have to go. Hopefully your gain. Ive owned this since the 2007not original owner from new. It was part of a PA that was used part time up until 2017 and then has been rarely used. Its always been stored in a temperature and humidity-controlled shop. It does have some scratches on the top and bottom. There is also rack rash on the rack ears. The inside is very clean for an of this age. It has always worked flawlessly, and I tested it before listing. Im including the power cords, manual copied, and the . The is heavy 46lbs. It will be packed well for shipping. Some specs below Fully modular dual monaural design from power switch to AC line cord. High efficiency 50 input to output. Positive locking detachable dual AC line cords. Compact only 12.75 deep. Rugged, quiet, 100 CFM thermally controlled cooling system. Compression circuit for long term excessive high frequencies signals. Remote sequential power onoff feature. Clipping eliminator circuit.PROTECTION FEATURESShort CircuitExcessive high frequencyThermalClipping eliminatorDC offsetSoft startinput mute Separate LR AC line fuses CONTROLSDual power switchesDual sequence switchesDual 11 detents level controlsXLR phasing switchSeries mono switchDual mono switchClipping eliminator switchGround liftSpecifications for the Carver PT-18008-ohm FTC rated powerch 600W4-ohm FTC rated powerch 900W2-ohm dynamic powerch 1100W48-ohm FTC rated THD lt 0.5 THDInput Impedance Line 5K ohms each legGain 32 dBSlew Rate 25VusDing 200 1kHzDimensions HxWxD inches 5.25 x 19 x 12.75Comments Connections Input XLR, barrier strip Output 5-way binding posts, 2 setschannel
